Checking The Rear Constant Velocity Shaft Assemblies; Assembling The Rear Constant Velocity Shaft Assemblies - Yamaha 2016 Grizzly yfm700gplg Service Manual

REAR CONSTANT VELOCITY SHAFT ASSEMBLIES, FINAL
EBS30254
CHECKING THE REAR CONSTANT
VELOCITY SHAFT ASSEMBLIES
The following procedure applies to both of the
rear constant velocity shaft assemblies.
1. Check:
• Double offset joint splines
• Constant velocity joint splines
• Constant velocity shaft splines
Wear/damage → Replace.
2. Check:
• Dust boots
Cracks/damage → Replace.
ECB01590
NOTICE
Always use a new boot band.
3. Check:
• Balls and ball races
• Inner surface of double offset joint
Pitting/wear/damage → Replace.
EBS30255
ASSEMBLING THE REAR CONSTANT
VELOCITY SHAFT ASSEMBLIES
The following procedure applies to both of the
rear constant velocity shaft assemblies.
1. Install:
• Clip "1"
New
• Constant velocity joint "2"
• Constant velocity shaft "3"
• Dust boot
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Install the clip.
b. Install the constant velocity joint.
TIP
• Install the clip into the groove in the constant
velocity shaft as shown.
• Secure the constant velocity joint in a vise, and
then fit the constant velocity shaft into the con-
stant velocity joint using a hammer.
A
New
1
DRIVE ASSEMBLY AND REAR DRIVE SHAFT
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
3
A
New
1
A
A. Wheel side
▲ ▲▲▲ ▲ ▲▲▲ ▲
2. Install:
• Dust boot
• Ball bearing "1"
• Circlip "2"
• Double offset joint "3"
• Clip "4"
TIP
▼▼▼
• Securely install the circlip into the groove in the
constant velocity shaft.
• Securely install the clip into the groove in the
double offset joint.
B
8-22
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
New
New
1
3
2
▲ ▲▲▲ ▲ ▲▲▲
2
New