Yamaha 2016 Grizzly yfm700gplg Service Manual page 463

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
Diagnostic
code No.
01 Throttle angle
• Fully closed position
03 Pressure difference
(atmospheric pressure and
intake air pressure)
05 Intake air temperature
06 Coolant temperature
07 Vehicle speed pulse
08 Lean angle sensor output
voltage
• Upright
• Overturned
09 Fuel system voltage
(battery voltage)
21 Neutral switch
• Neutral
• In gear
60 EEPROM fault code display
61 Malfunction history code dis-
play
• No history
• History exists
Item
14–20
Displays the intake air pres-
sure.
Displays the intake air tem-
perature.
Displays the coolant tem-
perature.
0–999
3.6–4.4
0.7–1.3
Approximately 12.0
ON
OFF
The fault code No. 44 detect-
ed EEPROM errors are indi-
cated.
00 indication: Normal status
00
Fault codes 12–50
• (If more than one code
number is detected, the
display alternates every
two seconds to show all the
detected code numbers.
When all code numbers are
shown, the display repeats
the same process.)
10-8
Display
Check with throttle valve fully
closed.
Set the engine stop switch to
"
throttle while pushing the
start switch "
play value changes, the per-
formance is OK.)
Compare the actually mea-
sured intake air temperature
with the indicated value.
Compare the actually mea-
sured coolant temperature
with the indicated value.
Check that the number in-
creases when the rear
wheels are rotated.
The number is cumulative
and does not reset each time
the wheel is stopped.
Remove the lean angle sen-
sor and incline it more than
65 degrees.
Turn the main switch to "
(on), and then compare the
actually measured battery
voltage with the display val-
ue. (If the actually measured
battery voltage is low, re-
charge the battery.)
Shift the transmission.
—
—
—
Procedure
", and then operate the
". (If the dis-
"