Yamaha 2016 Grizzly yfm700gplg Service Manual page 71

1. AC magneto/crankshaft position sensor lead
2. ISC unit lead
3. Final drive case breather hose
4. Negative battery lead
5. Starter motor lead
6. Throttle body breather hose
7. Coolant temperature sensor lead
8. Throttle cable
9. Wire harness
10. Main switch lead
11. Auxiliary DC jack lead
12. Ignition coil lead
13. EPS motor coupler (for EPS models)
14. Differential motor lead
15. EPS torque sensor coupler (for EPS models)
16. Radiator inlet hose
17. Radiator fan motor lead
18. Spark plug lead
19. Brake pedal cable
20. Shift control cable
21. Gear position switch lead
22. Speed sensor lead
23. Reverse switch lead
A. Route the ISC unit lead to the inside of the fuel
hose and AC magneto/crankshaft position sensor
lead.
B. Route the throttle body breather hose under the
throttle cable.
C. Pass the final drive case breather hose and throttle
body breather hose through the hole on the battery
cover.
D. Route the radiator fan motor lead between the
electrical components tray and the radiator inlet
hose.
E. Fasten the radiator fan motor lead and radiator fan
motor breather hose to the frame with the plastic
band, making sure to face the end of the band
inward. Be sure to fasten the plastic band around
the protective sleeve of the lead, not the lead itself.
F. Route the spark plug lead to the inside of the rear
brake cable and shift control cable.
G. Fasten the hose, leads, and wire harness with the
plastic band, making sure to position the band near
the split in the wire harness.
H. Face the end of the plastic band inward.
°
I. 45
J. Insert the projection on each coupler into the hole
in the frame from the inside of the frame.
K. For EPS models
L. Except for EPS models
M. Fasten the spark plug leads with the larger
diameter section of each holder.
2-40
CABLE ROUTING