Checking The Front Brake Hoses; Checking The Rear Brake Hoses - Yamaha 2016 Grizzly yfm700gplg Service Manual

Table of Contents

Advertisement

6
5
4
6
4
5
h. Adjust the drive select lever control cable.
Refer to "ADJUSTING THE DRIVE SELECT
LEVER CONTROL CABLE AND SHIFT
ROD" on page 3-32.
EWB03740
WARNING
After this adjustment is performed, lift the
front and rear wheels off the ground by plac-
ing a block under the engine, and spin the
rear wheels to ensure there is no brake drag.
If any brake drag is noticed perform the
above steps again.
i. Install the front fender inner panel (right).
Refer to "GENERAL CHASSIS (3)" on page
4-8.
▲▲▲
▲ ▲▲▲
▲ ▲▲▲
EBS30461

CHECKING THE FRONT BRAKE HOSES

The following procedure applies to all of the
brake hoses and brake hose clamps.
1. Check:
• Front brake hoses "1"
Cracks/damage/wear → Replace.
▲ ▲▲▲
▲ ▲▲▲
▲ ▲▲▲
PERIODIC MAINTENANCE
2. Check:
• Brake hose holders
Loose → Tighten the holder bolt.
3. Apply the brake several times.
4. Check:
• Brake hoses
Brake fluid leakage → Replace the damaged
hose.
Refer to "FRONT BRAKE" on page 4-26.
EBS30582

CHECKING THE REAR BRAKE HOSES

The following procedure applies to all of the
brake hoses and brake hose clamps.
1. Check:
• Rear brake hoses "1"
Cracks/damage/wear → Replace.
▲▲▲
3-13
1
1
1
1

Advertisement

Table of Contents
loading

Table of Contents