Disassembling The Rear Constant Velocity Shaft Assemblies - Yamaha 2016 Grizzly yfm700gplg Service Manual

REAR CONSTANT VELOCITY SHAFT ASSEMBLIES, FINAL
EBS30253
DISASSEMBLING THE REAR CONSTANT
VELOCITY SHAFT ASSEMBLIES
The following procedure applies to both of the
rear constant velocity shaft assemblies.
1. Remove:
• Boot band "1"
Use the boot band installation tool "2".
Boots band installation tool
90890-01526
Boots band installation tool
YM-01526
A
2
A. Final drive side
2. Remove:
• Clip "1"
• Double offset joint "2"
• Circlip "3"
• Ball bearing "4"
• Dust boot "5"
TIP
Before removing the clip, slide the dust boot
away from the double offset joint.
A
5
DRIVE ASSEMBLY AND REAR DRIVE SHAFT
1
2
1
8-21
A
A. Final drive side
3. Remove:
• Boot band "1"
Use the boot band installation tool "2".
Boots band installation tool
90890-01526
Boots band installation tool
YM-01526
B
2
B. Wheel side
4. Remove:
• Dust boot
• Constant velocity joint
• Clip
TIP
Secure the constant velocity shaft in a vise, and
then remove the constant velocity joint using
hammers.
B
B. Wheel side
4
3
1