Checking The Coolant Level; Changing The Coolant - Yamaha 2016 Grizzly yfm700gplg Service Manual

EBS30035

CHECKING THE COOLANT LEVEL

1. Place the vehicle on a level surface.
TIP
The coolant level must be checked on a cold en-
gine since the level varies with engine tempera-
ture.
2. Check:
• Coolant level
The coolant level should be between the
maximum level mark "a" and minimum level
mark "b".
Below the minimum level mark → Add the
recommended coolant to the proper level.
ECB01300
NOTICE
• Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant check, and if nec-
essary, correct the antifreeze concentra-
tion of the coolant.
• Use only distilled water. However, if dis-
tilled water is not available, soft water may
be used.
a
b
3. If the coolant is at or below the minimum level
mark, remove the side panel (left).
Refer to "GENERAL CHASSIS (1)" on page
4-1.
4. Remove the reservoir cap "1", add coolant or
distilled water to the maximum level mark "a",
install the reservoir cap and then install the
side panel (left).
Coolant reservoir (up to the maxi-
mum level mark)
0.25 L (0.26 US qt, 0.22 Imp.qt)
PERIODIC MAINTENANCE
EBS30036

CHANGING THE COOLANT

1. Remove:
• Side panel (left)
• Side panel (right)
Refer to "GENERAL CHASSIS (1)" on page
4-1.
• Upper panel
Refer to "GENERAL CHASSIS (2)" on page
4-6.
• Footrest board (left)
Refer to "GENERAL CHASSIS (4)" on page
4-11.
2. Remove:
• Coolant reservoir cap "1"
3. Disconnect:
• Coolant reservoir hose "2"
4. Drain:
• Coolant
(from the coolant reservoir)
5. Connect:
• Coolant reservoir hose
3-29
1
a
1
2