Installing The Horizontal Stabilizer - Seagull Models CHEROKEE Instruction Manual

1
3
4) Slide the wheel pant into position and insert
the screw into the holes to secure the wheet
pant to the landing gear mount as shown.
4
2mm.
4
2mm.
3.
M3x10mm.
www.seagullmodels.com
M3x15mm.
2
2
5) Slide a wheel onto the axle. Prepare a
second wheel collar with a machine screw and
threadlock then install it on the axle to retain
the wheel.
5
6
7

INSTALLING THE HORIZONTAL STABILIZER.

1) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at the trail-
ing edge, and place a mark. Use a triangle
and extend this mark, from back to front,
across the top of the stabilizer. Also extend
this mark down the back of the trailing edge of
the stabilizer.
2) Using a modeling knife, carefully remove
the covering at mounting slot of horizontal sta-
bilizer ( both side of fuselage).
6
Draw center line.
21