Landing Gear Installation - Seagull Models CHEROKEE Instruction Manual

CHEROKEE
Pushrod tube hole.
5) Slide the pushrod tube in the firewall and
guide it through the fuel tank mount. Use
medium C/A to glue the tube to the firewall
and the fuel tank mount.
6) Connect the Z-bend in the 450mm throttle
pushrod to the outer hole of the carburetor
arm.
7) Slide the throttle pushrod wire into the
tube. Position the engine between the
mounts. Use four 3x25mm machine screws to
secure the engine to the mount as shown.
Pushrod wire.
Trim and cut.
Machine screw M3x25mm.
8) Reinstall the servo horn by sliding the
connector over the pushrod wire. Center the
throttle stick and trim and install the servo horn
perpendicular to the servo center line.
12
Instruction Manual.
Linkage.
.
9) Move the throttle stick to the closed position
and move the carburetor to closed. Use a 2.5mm
hex wrench to tighten the screw that secures
the throttle pushrod wire. Make sure to use
threadlock on the screw so it does not vibrate
loose.

LANDING GEAR INSTALLATION:

A. NOSE GEAR:
1) Locate the items necessary to attach the
nose landing gear that are included with your
model.
1
2
M3x10mm.
3
4
7
6
5