Mounting The Engine; Installing The Switch - Seagull Models CHEROKEE Instruction Manual

THROTTLE SERVO ARM INSTALLATION.
Install adjustable servo connector in the servo
arm as same as picture below:
Loctite secure.
Nut.
Throttle servo arm.

INSTALLING THE SWITCH.

Install the switch into the precut hole in the
side, in the fuselage.
Trim and cut.
Switch.
www.seagullmodels.com
Adjustable Servo
connector.
Servo arm.
Elevator servo arm.
Rudder servo arm.
3/ 32" Hole.

MOUNTING THE ENGINE.

1) Position the engine with the drive washer
(110mm) forward of the firewall as shown.
110mm.
2) Use a pin drill and 2mm drill bit to drill a
small indentation in the mount for the engine
mounting screw.
3) Use a drill to drill the four holes in the engine
mount rails.
2mm diameter.
4) On the fire wall has the location for the
throttle pusshrod tube (pre-drill).
11