Table of Contents
Advertisement
RENO AIR CARE YAK-11 "PERESTROIKA"
1.
he propeller should not touch any
part of the spinner cone. If it does, use a
sharp modeling knife and carefully trim
away the spinner cone where the propel-
ler comes in contact with it.
2.
HINGING THE ELEVATOR.
Glue the elevator hinges in place using
the same techniques used to hinge the ai-
lerons.
1.
INSTALL ELEVATOR CONTROL HORN.
24
Instruction Manual.
1.
Fiberglass control horn.
2.
3.
ElevatorFiberglass control horn.
INSTALLING THE HORIZONTAL
STABILIZER.
1) Using a ruler and a pen, locate the cen-
terline of the horizontal stabilizer, at the
trailing edge, and place a mark. Use a tri-
angle and extend this mark, from back to
front, across the top of the stabilizer. Also
extend this mark down the back of the
trailing edge of the stabilizer.
Epoxy.
Epoxy.
Advertisement
Table of Contents
