RENO AIR CARE YAK-11 "PERESTROIKA"
HINGING THE ELEVATOR
Glue the elevator hinges in place using
the same techniques used to hinge the ai-
lerons.
1.
INSTALL ELEVATOR CONTROL HORN
1.
Fiberglass control horn.
2.
24
Epoxy
Instruction Manual.
3.
ElevatorFiberglass control horn
INSTALLING THE HORIZONTAL
STABILIZER
Using a ruler and a pen, locate the cen-
terline of the horizontal stabilizer, at the
trailing edge, and place a mark. Use a tri-
angle and extend this mark, from back to
front, across the top of the stabilizer. Also
extend this mark down the back of the
trailing edge of the stabilizer.
1.
Using a modeling knife, carefully remove
the covering at mounting slot of horizon-
tal stabilizer ( both side of fuselage).
2.
Epoxy.