Table of Contents
Advertisement
Messerschmitt Bf 109E 60
Elevator iberglass control horn.
INSTALLING THE HORIZONTAL
STABILIZER.
Using a ruler and a pen, locate the
terline of the horizontal stabilizer, at the
trailing edge, and place a mark. Use a tri-
angle and extend this mark, from back to
front, across the top of the stabilizer. Also
extend this mark down the back of the
trailing edge of the stabilizer.
Using a modeling knife, carefully re
move the covering at mounting slot of
horizontal stabilizer ( both side of fuse-
lage).
Slide the stabilizer into place in the
precut slot in the rear of the fuselage. he
stabilizer should be pushed irmly against
the front of the slot.
22
Epoxy.
cen-
Draw center line
-
Cut.
Instruction Manual.
With the stabilizer held irmly in place,
use a pen and draw lines onto the stabi-
lizer where it and the fuselage sides meet.
Do this on both the right and let sides
and top and bottom of the stabilizer.
Pen
Remove the stabilizer. Using the lines
you just drew as a guide, carefully remove
the covering from between them using a
modeling knife.
When cutting through the covering
to remove it, cut with only enough pressure
to only cut through the covering itself. Cut-
ting into the balsa structure may weaken
it.
Using a modeling knife, carefully re
move the covering that overlaps the sta-
bilizer mounting platform sides in the
fuselage. Remove the covering from both
the top and the bottom of the platform
sides.
.
Trim and cut
-
Advertisement
Table of Contents
