www.seagullmodels.com
Wing pannel.
Aileron.
Repeat the procedure for the other
aileron servo.
MAIN LANDING GEAR
Clevis.
INSTALLATION.
INSTALLING THE MAIN GEAR WIRES.
Pen.
Aileron torque rod.
3mm x 10mm.
Cut.
1) Using a modeling knife, remove the cov-
ering from over the two main gear mounting
slots located in the bottom of the wing. One
slot is located in each wing half.
Mounting slot.
M2 clevis.
M2 lock nut.
Snap keeper.
Remove covering.
2) Insert the 90º bend of one main gear
wire into the predrilled hole in one mounting
slot.
3) The landing gear wire is held in place
using two nylon landing gear straps and four
3mm x 10mm wood screws.
9