Section 11: Fuel Tank Assembly - Hangar 9 F4U Corsair .60 ARF Assembly Manual

Section 10: Throttle Pushrod Installation
Step 6
Attach the "Z" bend on the throttle pushrod wire onto
the carburetor arm. Slide the pushrod wire into the
tube and secure the engine to the firewall.

Section 11: Fuel Tank Assembly

Required Parts
• Clunk (fuel pickup)
• Fuel pickup tubing
• Rubber stopper
• Metal tubes (short and long)
Required Tools and Adhesives
• Phillips screwdriver (small) • Hobby knife
Note: The stopper provided with the
Corsair has three holes that are not bored
completely through the stopper. The holes
are for the fuel pickup, fill, and vent lines. For
these instructions only, two holes will be
used: one for the fuel pickup and one for the
fuel vent. Only open the third hole if you are
going to use a separate fill line.
28
• Metal caps (2)
• Fuel tank
• M3x20 screw
Step 1
Locate the fuel tank parts.