6-23
CYLINDER HEAD, CYLINDER AND PISTON
ENGINE TOP SIDE ASSEMBLY
PISTON AND PISTON RING INSTALLATION
Install the piston and piston ring in the reverse order of removal.
Pay attention to the following points:
PISTON RING
• Install the piston rings in the order of oil ring and 1st ring.
• The first member to go into the oil ring groove is a spacer 1.
After placing the spacer, fit the two side rails 2.
NOTE:
Side designations, top and bottom, are not applied to the spacer
and side rails: you can position each either way.
When installing the spacer 1, be careful not to allow
its two ends to overlap in the groove.
• Be sure to bring the concave side of 1st ring to the top when
fitting it to the piston.
• Position the gaps of the two ring as shown. Before inserting a
piston into the cylinder, check that the gaps are so located.
CAUTION
A INCORRECT
B CORRECT
C 1st ring
D Upper side rail
E Spacer
F Lower side rail
IN
EX