Suzuki RM-z450 Owner's Service Manual page 169

OIL PUMP No.2
Install the oil pump No.2 in the reverse order of removal. Pay
attention to the following points:
• Install the pin 2 into the oil pump No.2 shaft 1.
• Install the inner rotor 3 onto the oil pump No.2 shaft 1.
NOTE:
Fit the slot A of the inner rotor onto the pin 2.
• Apply engine oil to the oil pump shaft, outer rotor and inner
rotor.
• Install the oil pump No.2 shaft and inner rotor onto the crank-
case.
• Install the outer rotor 4 onto the crankcase.
Face the punch mark B on outer rotor 4 to the crank-
case.
• Install the oil strainer No.2 5 and snap ring 6.
Replace the snap ring 6 with a new one.
" 09900-06108: Snap ring pliers
• Install the oil pump No.2 cover 7 and tighten the oil pump
No.2 bolts to the specified torque.
% Oil pump No.2 bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
• Install the magneto cover. (!15-19)
• Install the gearshift lever. (!9-7)
INSPECTION AFTER INSTALLATION
• Engine oil level and oil leakage (!2-10)
• Engine coolant level and coolant leakage (!2-14, -15)
• Oil pressure (!2-36)
CAUTION
CAUTION
LUBRICATION SYSTEM 11-8