Suzuki RM-z450 Owner's Service Manual page 111

CYLINDER HEAD
• Install the dowel pins into the cylinder and then install the cyl-
inder head gasket 1 onto the cylinder.
Use the new gasket to prevent gas leakage.
• Place the cylinder head 2 on the cylinder.
Do not drop the cam chain into the crankcase.
• Apply engine oil to the washers and thread portion of the bolts
before installing the cylinder head bolts.
• With the head snugly seated on the cylinder, secure it by tight-
ening the bolts in diagonal stages.
• Tighten the cylinder head bolts to the specified torque.
$ Cylinder head bolt: Initial 25 N·m (2.5 kgf-m, 18.0 lb-ft)
• After tightening the cylinder head bolts to specification, tighten
the cylinder head base bolts 3 and cylinder base bolt 4 to
the specified torque.
$ Cylinder head base bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
Cylinder base bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Connect the ECT sensor coupler.
• Install the engine mounting upper brackets. (!5-6)
• Install the exhaust pipe. (!5-9)
• Connect the radiator hose. (!20-23)
• Install the throttle body. (!13-15)
CAUTION
CAUTION
Final 51 N·m (5.1 kgf-m, 37.0 lb-ft)
CYLINDER HEAD, CYLINDER AND PISTON 6-26