Suzuki RM-z450 Owner's Service Manual page 83

• Connect both ends of the drive chain with the joint pin 3
inserted from the wheel side F as installed on the motorcycle.
4 O-ring seal ... 4 pcs.
5 Joint plate
Replace the joint, clip and O-ring seals with new ones.
NOTE:
When installing the joint plate 5, its stamp mark must face the
outside.
• Reassemble the drive chain clip so the slit end faces opposite
the direction of rotation.
• Tighten the engine sprocket cover bolts to the specified
torque.
NOTE:
Fit the clamp G to the sprocket cover bolt.
$ Engine sprocket cover bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
• Install the gearshift lever in the correct position.
• Apply grease to the brake pedal pivot bolt.
% 99000-25010: SUZUKI SUPER GREASE "A"
• Install the brake pedal and brake pedal spring. (!20-23)
$ Brake pedal pivot bolt: 29 N·m (2.9 kgf-m, 21.0 lb-ft)
CAUTION
ENGINE REMOVAL AND INSTALLATION
or equivalent
5-7
Direction of travel