Suzuki RM-z450 Owner's Service Manual page 114

6-29 CYLINDER HEAD, CYLINDER AND PISTON
• Install the camshaft journal holder.
• Have the camshaft journal holder evenly by tightening the
camshaft journal holder bolts lightly, in the ascending order of
numbers.
NOTE:
* When tightening the camshaft journal holder bolts, the piston
position must be at TDC on the compression stroke.
* The ascending order of numbers are indicated on the cam-
shaft journal holder.
• Tighten the camshaft journal holder bolts in ascending order
of numbers to the specified torque.
$ Camshaft journal holder bolt: 10 N·m
CAM CHAIN TENSION ADJUSTER
• Retract the push rod by pushing the stopper 1.
• Install a new gasket 2.
Use the new gasket to prevent oil leakage.
• Install the cam chain tension adjuster 3 with "UP" mark faced
upward.
• Tighten the cam chain tension adjuster mounting bolts to the
specified torque.
$ Cam chain tension adjuster mounting bolt:
• Install the spring 4.
(1.0 kgf-m, 7.0 lb-ft)
CAUTION
10 N·m (1.0 kgf-m, 7.0 lb-ft)
6 2
7
3
1 5 4
8