Suzuki RM-z450 Owner's Service Manual page 115

• Install the gasket 5 and cam chain tension adjuster cap bolt
6.
NOTE:
Click sound is heard when the cam chain tension adjuster cap
bolt is installed.
• Tighten the cam chain tension adjuster cap bolt to the speci-
fied torque.
$ Cam chain tension adjuster cap bolt:
After installing the cam chain tension adjuster, check
to be sure that the adjuster works properly by check-
ing the slack of cam chain.
• After installing the cam chain tension adjuster, rotate the
crankshaft (two turns), and recheck the positions of the cam-
shafts. (!6-28)
After this procedure, if any resistance is felt while
turning over the crankshaft, stop immediately, and
check the camshaft chain timing.
• Inspect the valve clearance. (!2-20)
• Apply grease to the O-rings.
Use the new O-rings to prevent oil leakage.
' 99000-25010: SUZUKI SUPER GREASE "A"
• Tighten each plug to the specified torque.
$ TDC plug: 14 N·m (1.4 kgf-m, 10.0 lb-ft)
Crankshaft hole plug: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
• Install the magneto cover guard and pour engine oil.
(!2-11)
23 N·m (2.3 kgf-m, 16.5 lb-ft)
CAUTION
CAUTION
CAUTION
CYLINDER HEAD, CYLINDER AND PISTON
or equivalent
6-30