Husqvarna 2009 TE 250 Owner's Manual page 157

MUM2-250_310_450_510_2009_GB
EXHAUST MUFFLER (TC-TE-TXC)
The muffler reduces the noise of the exhaust gases, but it is an
integral part of the exhaust as well. As such, its conditions affect
the motorcycle performance.
When the noise on the exhaust is too high, it means that the
deadening material set on the holed tube inside the muffler is
deteriorated.
WARNING: Check the deadening material
after every competition and replace it if
necessary.
21-05-2008 9:38 Pagina 65
REPLACING THE MUFFLER DEADENING MATERIAL
First turn counterclockwise fastening rear pin (1) then remove
saddle, screws (2) and L.H. side panel (3). Using an 8 mm T-
shaped spanner on the outside and a 10 mm T-shaped spanner
on the inside, remove the locking screw (4) of the muffler.
Remove the spring (5) and with an 8 mm T-shaped spanner re-
move the screw (8); then pull out the muffler.
Remove the six rear rivets (6), clamp and the exhaust terminal
(7).
Remove innner pipe and replace the deadening material.
Reassemble L.H. side panel and saddle.
NOTE: When diffuculties are found in re-
moving the muffler, lightly beat with a
rubber or plastic hammer.
2
3
6
7
4
5
8
65