Husqvarna 2009 TE 250 Owner's Manual page 143

MUM2-250_310_450_510_2009_GB
REASSEMBLING THE FRONT WHEEL
Fit the L.H. spacer on the wheel hub.
TE-TC-TXC: Fit the wheel between the front fork legs so that the
brake disc is fitted into the caliper.
SMR: Fit the wheel between the front fork legs.
Fit the wheel axle (2) from the R.H. side, after greasing it and
push it to the stop on the L.H. leg; during this operation, the
wheel should be turned. Tighten the screw (3) on the fork L.H.
side but DO NOT lock it. Now, pump for a while, pushing the
handlebar downwards until you are sure that the fork legs are
perfectly aligned.
21-05-2008 9:37 Pagina 51
Lock: the screws (1) on the R.H. leg (10,4 Nm/ 1,05 Kgm/ 7.7
ft-lb), the screw (3) on the L.H. side (51,45 Nm/ 5,25 Kgm/ 38
ft-lb), the screws (1) on the L.H. leg (10,4 Nm/ 1,05 Kgm/ 7.7
ft-lb).
SMR: fit the brake caliper on the disc; assemble the caliper on its
holding plate and tighten the screws (A) at 25,5 Nm/ 2,6 Kgm/
18.8 ft-lb.
Check that the brake disc slides between the caliper pads without
any friction.
NOTE
After reassembly, pump the brake control lever until the pads
are against the brake disc.
TE-TC-TXC
2
TE-TC-TXC
TE-TC-TXC
1
1
3
SMR
51