Husqvarna 2009 TE 250 Owner's Manual page 144

MUM2-250_310_450_510_2009_GB
REMOVING THE REAR WHEEL
Unscrew the nut (1) of the wheel pin (3) and extract it. It is not
necessary to unloose the chain adjusters (2); in this way, the
chain tension will remain unchanged after the reassembly.
Extract the complete rear wheel, by taking care of the spacers lo-
cated at the hub sides.
To reassemble, reverse the above procedure remembering to in-
sert the disc into the caliper.
1
52
21-05-2008 9:37 Pagina 52
NOTES
Do not operate the rear brake pedal when the wheel has been
removed; this causes the caliper piston to move outwards.
After removal, lay down the wheel with brake disc on top.
After reassembly, pump the brake control pedal until the pads
are against the brake disc.
2