Husqvarna 2009 TE 250 Owner's Manual page 112

MUM1-250_310_450_510_2009_GB
REAR BRAKE CONTROL
The rear brake control (1) is placed on the right-hand side of the
motorcycle. On models TE and SMR as stop switch, during the
braking action, causes the rear light to come on.
20
21-05-2008 9:28 Pagina 20
GEAR SHIFT CONTROL
The lever (1) is placed on the left-hand side of the engine. The
operator must release the lever after each gear change to allow
it to return to its central position before another gear
change can be made.
Neutral position (N) is between first (low) and second gears. First
gear is engaged by pushing the lever downwards; all the other
gears are engaged, by pushing the lever upwards.
The position of the gear shift lever on the shaft can be varied by:
- loosening screw;
- pulling lever out;
- placing lever in new position on the shaft when the operation
is over tighten the screw and then tightening the screw.
CAUTION*: Do not shift gears without dis-
engaging the clutch and closing the throt-
tle. The engine could be damaged by over-
speed and shock.
WARNING*: Do not downshift when travel-
ing at a speed that would force the engine
to overrev in the next lower gear, or cause
the rear wheel to lose traction.
N: Neutral
TC
Neutral
N:
1
TE-SMR-TXC
1