Husqvarna 2009 TE 250 Owner's Manual page 121

MUM1-250_310_450_510_2009_GB
CHECKING THE OIL LEVEL
Keeping the motorbike level and in a vertical position, check the oil
level through the inspection (1) window on the right crankcase.
Make sure the level is in between the MIN and MAX notches.
To fill up, remove the filler cap (2).
Note*: Have this operation made with
warmed-up engine.
WARNING*: Be careful not to touch hot en-
gine oil.
1
2
21-05-2008 9:29 Pagina 29
ENGINE OIL REPLACEMENT AND BAG FILTERS-
FILTER CARTRIDGE CLEANING OR REPLACEMENT
WARNING*: Be careful not to touch hot en-
gine oil.
Drain the oil with WARM ENGINE; proceed as follows:
- remove oil filler cap (2);
- remove the engine guard (A)
- place an oil drain pan under the engine block
- remove the oil drain cap (3)
- drain the used oil completely then clean the magneto on the cap;
MAX
MIN
2
- remove the three filters (5), (6) and (7) on the L.H. side of the
engine, check O-Rings for wear then clean filters with fuel; re-
assemble using the reverse procedure;
- in order to replace the filter cartridge (4), unscrew the three
fastening screws then the filter cartridge cover;
- after filters replacement, reassemble the drain cap (3), the en-
gine guard (A) then pour the recommended oil quantity.
A
4
3
29