Table of Contents
Advertisement
The screen Channel Search allows you to adjust the antenna and the antenna power for good reception
of signals and for perfect channel scanning.
note
Frequency channel:
Frequency (MHz):
Antenna Power:
When all settings have been made (including antenna adjustment), press blue on the remote control to
perform full scanning for channels through all frequency channels range.
The receiver will start searching for channels. Information about found TV and radio channels, scanned
frequency, current signal strength and quality values and indicators as well as search progress line will
be displayed on screen. After completing the channels scan, the receiver will save all found TV and
radio channels and switch to viewing mode of the TV channel with the lowest number according to the
current channel list numbering.
note:
4.2 activation of the receiver in the digital terrestrial Tv operator's
network
IMporTanT
After the first turn the receiver will automatically receive additional information from the digital
broadcasts. The process of obtaining the data may take several minutes, during which the receiver will
display a message that there is no right to watch a channel. At this time, do not change channels. Wait
for the image of the transmitted channel.
8
For effective usage of this tool, you should know the frequency channel
numbers for digital aerial broadcasting in your region by your operator.
Correct antenna adjustment is very important to complete scanning and for
comfortable view. You can skip this step by pressing blue at any time and
perform a full scanning without antenna tuning.
Select a frequency channel on which broadcasting is present in your area.
Adjust the antenna such wise as to achieve the best level and quality values of
the signal for the selected frequency channel.
Reference information about frequency for the selected frequency channel.
Use tu to start/stop antenna power supply from the receiver via the
antenna connector. Before connecting your antenna to the receiver, please
read the user manual of your antenna regarding antenna powering. This
parameter is recommended to set to ON only for active internal or external
antennas which require power supply via an antenna cable with voltage of 5
V DC and consume less than 50 mA. Otherwise, leave the setting OFF.
If any channels were not found, please repeat the previous step of the
antenna adjustment and perform the scan again or ask your local dealer or
service for assistance.
Your receiver is pre-activated to show most of the encoded digital terrestrial
channels broadcasts by the operator on a free basis to subscribers.
However, watching some channels may require a subscription fee. To
gain access to paid channels, you should contact your Customer Support.
Information required to contact the Customer Support can be found in the
additional instructions that came with the documentation supplied with
the receiver.
PART 3 • English
Advertisement
Table of Contents
