Multimedia - Strong SRT 8530 User Manual

Press oK
„ „
The receiver will check if new version of software is available. If it available then download of
„ „
software will start, progress will be indicated on screen.
Once download process is completed the receiver reboot and update software to the new version.
„ „
Once update is completed the receiver will restart and you can continue to use it.
„ „
Warnings:
Non-compliance with update recommendations can damage your receiver and warranty could be
„ „
void!
Do not take any action during update process, until the receiver has not restarted or the error
„ „
message does not appear.
Do not disconnect the receiver from the mains or switch the power off until the software update is
„ „
completed.
Do not disconnect the USB device from the receiver until the software update has been completed.
„ „
To update software via usb
Check the software version of the receiver (see chapter 6.5.1) and compare it with the currently
„ „
available upgrade version on our website www.strong.tv. If the versions are the same, there is no
need for update.
Download the latest software version update file which contains software image and manual for
„ „
updating.
Please follow the recommendations from the manual to go through update procedure.
„ „
Warnings:
Non-compliance with update recommendations can damage your receiver and warranty could be
„ „
void!
Do not take any action during update process, until the receiver has not restarted or the error
„ „
message does not appear.
Do not disconnect the receiver from the mains or switch the power off until the software update is
„ „
completed.
Do not disconnect the USB device from the receiver until the software update has been completed.
„ „
software update over the air
Your receiver can update software via digital terrestrial broadcast as well. You can find out via your local
support or dealer whether there is a new software version broadcasted in your area.
When you know that there is an update available, enter this submenu to check for the new version and
to start the update procedure from broadcast signal.
If the operator needs to update the software while you are watching TV or radio channels, the receiver
can automatically switch to update mode.
In any case, during the update procedure the receiver will restart in update mode and will show the
update screen with the progress bar. After the software upgrade the receiver will reboot automatically
and tune to the last viewed channel.
Warnings:
Do not take any action during the update process until the receiver has not restarted or the error
„ „
message does not appear.
Do not disconnect the receiver from the mains or switch the power off until the software update is
„ „
completed.

6.4 Multimedia

Use tu to access the menu Multimedia in the main menu, which includes following submenus: Records
List, Movie, Music, Photo and Multimedia Config.
22
PART 3 • English