Software Update - Strong SRT 8530 User Manual

PART 3 • English
Time:
Duration:
Enable:
Press to save settings. If a timer has been enabled it will be added to the timers list.
The execution of the timer depends on the current operation mode of the receiver:
in viewing mode the receiver will notify you 10 seconds before the timer starts the scheduled event.
„ „
You can confirm the timer by pressing oK or cancel it with
will be executed. After the timed event is finished, the receiver will switch to the last viewed channel;
in standby mode the receiver will automatically turn on, execute the timer and scheduled event and
„ „
return to standby mode.
Edit:
Delete:
6.3.2 Time adjust
This submenu allows you to select mode of time and date synchronization, adjust time and date
parameters in manual mode.
Auto time setting:
note:
note:
GMT Offset:
Summer Time:
Current Date:
Current Time:

6.3.3 software update

Software for your receiver can be updated in 3 ways:
Over the Internet;
„ „
Via USB;
„ „
Over the Air (OTA).
„ „
Press oK to select the updating method from the submenu.
To update software over internet
After selecting of this option you will be notified to insert USB disk with not less than 60 Mbytes free
„ „
space to the USB connector at Front panel. Make sure to use USB disk with FAT32 file system.
Enter the time when the timer should be executed. Time format "hh:mm";
Enter the time interval during which the timer should be executed. Time
format "hh:mm";
Use tu to enable/disable a timer. Select Yes to activate the timer.
Use pq to select a timer to edit, press oK, make all necessary changes and
press to save the changes. All settings can be defined as described in
above.
Use pq to select a timer to be deleted and press blue. This timer will be
deleted from the timers list.
Use tu to enable/disable automatic time synchronization. The option
On means the synchronization date and time is made by the operator. The
option Off requires setting of time parameters manually.
The option Off not recommended due to the possibility of losing real time
settings after standby mode.
All parameters below can be adjusted only when "Auto time setting" set to
Off.
Use tu to select time zone in accordance with the country of residence, if
the automatic settings for your region are absent.
Use tu to enable/disable summer daylight saving time.
Press oK to select the current date from the calendar.
Use 0-9 to set the current time.
. If no actions are performed, the timer
21