Record Message - Docomo f-01c Instruction Manual

Call Telephone
When you cannot answer a call
Use an appropriate function according to a situation or place
where you cannot answer a call.

Record message

When Record message is set to "ON", a greeting message is played
and the caller can record message when you cannot answer the call.
a meg TEL functioneb Record message/Voice
memoed Record messageea ON
appears on the stand-by display.
Point
･
You can record up to 4 voice/videophone calls in total, approximately 30
seconds for each call. When reaching the savable number,
the stand-by display and Record message does not work. Delete
unnecessary recorded messages.
･
Even when Record message is not set to "ON", you can activate it only
once by pressing S for 1 second or more while receiving a call (Quick
recorded message).
･
Even when the greeting message is being played or a message is being
recorded, you can answer a call by pressing n (for videophone call,
I). In this case, the message before the call was answered canonot be
recorded.
Setting a response time : megbdceEnter time
Playing a recorded message : megbaeSelect a messageeSelect
whether to delete
46
Public mode
Public mode is an automatic answering service putting emphasis
on manners in a highly public place or when driving a car.
Public mode (Drive mode)
When there is an incoming call, a guidance message is played to
inform the other party of the reason that you cannot answer the
call and request to call back, and then the call ends.
a * (1 sec. or more)
appears on the stand-by display.
Point
appears on
･
In Public mode (Drive mode), no receiving action is performed, and calls
are recorded as Missed call.
Canceling : * (1 sec. or more)
Public mode (Power OFF)
When there is an incoming call while turning off the power, a
guidance message is played to inform the other party of the
reason that you cannot answer the call and request to call back,
and then the call ends.
a
Enter "*25251"en
Even when Public mode (Power OFF) is set, no indicators such
as icons appear on the display.
Point
Canceling : Enter "*25250"en
Checking the settings : Enter "*25259"en