Right Side Of Bp Lift Wire Is Loose - Riso ComColor IS900C Instruction Manual

S03-2011 (Right side of BP lift wire is loose)
Solutions and check point
Paper guide
You should check whether the paper
guide is not opened.
If the paper guide has big gap from the
BP belt, the paper guide might touch to
the maintenance unit, as a result, the
lift wire is loose.
69
Touch
Stopper
Basically the gap between guide pulley
and stopper is less than 6.5mm.
Guide pulley
(When maintenance unit is HP)
If the gap is over 6.5mm, it means the
unit doesn't return to HP enough, you
should check the wire harness
0 to 6.5mm
arrangement
Add very thin tape on the BP frame to
prevent catching from the BP shaft.
The BP unit can go down smoothly by
this tape.
When you don't have any tape, you
can change the shafts left and right.
Wire harness of BP unit might hang on
the guide. If the harness hang on it, BP
unit cannot go down enough. You can
cover them with craft tape etc.
Maintenance
BP unit
. (Harness of maintenance unit)