Signal Light Installation (Patlite) - Riso ComColor IS900C Instruction Manual

Signal light installation (Patlite)

1. Cut the harnesses 50cm from the pole end
If you change the pole to longer one, you must change it before
cutting the harness
2. Strip the cable 10mm from the harness end (Excluding blue line)
3. Wrap the harnesses with tape
4. Through the cord bushing and the bushing plate
Bushing plate
5. Crimp the connecter harness with same colour harness
each using a crimp tool
(Blue harness does not use)
Black
Same colour
32
10cm from the pole end
Tape
Cord bushing
Crimp
Black
6. Cut the left side cover
7. Fix the pole by two screws
Nut
8. Install the option PCB
9. Connect the harness onto CN6
Option PCB
Function
Patlite
Cut the cover
Spring washer
Normal washer
Screw
Insert the
harness