PREFACE
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
Copy
■ 5
You can set from 1 to 99 copies.
<The Copy function>
If you set the number of copies, the Craft ROBO cuts the same image repeatedly as shown
below.
The number of images that can be cut to the Y-direction and X-direction varies depending on
the sizes of the image and media.
Example: Copy is set to 10
• When the design orientation is landscape:
Start point
(origin)
• When the design orientation is portrait:
Y-direction
5
10
CHECKPOINT
(4) Follow steps 12 to 16 in "Cutting with new tool conditions."
4-6
CONTENTS
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
CH 4. CUTTING DATA SAVED ON SD CARD
Y-direction
1
2
3
4
6
7
8
9
4
3
2
1
9
8
7
6
•
When cutting is complete, the number of copies returns to 1.
•
If you set the number of copies to more than 2, the <Start Point> setting is canceled and
cutting starts from the origin shown in the illustration above.
•
Registration marks are ignored when cutting using the Copy function.
•
If the Craft ROBO detects that the output of the images you set using the Copy function
exceeds allowable cutting area, <OFFSCALE> is displayed. If you want to cut without
changing the setting, press [ENTER], then press or to select <Yes> in the <Cut?>
screen, and then press [ENTER] to start cutting. If you want to cancel cutting, press
[ENTER], then or to select <No> in the <Cut?> screen, then modify your setting in
the <Setting> screen by following steps 2 and 3.
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
APPENDIX A
APPENDIX A
Go Back
5
10
Start point
(origin)
CHAPTER 4. CUTTING DATA SAVED ON SD CARD
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
INDEX
INDEX