GRAPHTEC CC300-20 Craft ROBO User Manual page 27

PREFACE
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
(3) Select your model.
Click [Yes] or [No] to continue.
The installer of "ROBO Master," the software used for Print & Cut, starts up.
When the installation of ROBO Master is finished or cancelled, the installer of the Craft ROBO
Controller start up.
Installng the Craft ROBO Controller
(1) When the installer starts up, the screen shown below is displayed first.
Click [Next] to proceed.
(2) Next, a "Choose Destination Location" screen will be displayed.
Select the folder in which the Controller is to be installed.
Unless the folder shown by default does not have sufficient free space, it is normally not
necessary to change it. If there is no need to change the default folder, click [Next] to proceed.
(3) Next, a "Select Program Folder" screen will be displayed.
CHAPTER 3. CRAFT ROBO CONTROLLER
CONTENTS
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
CH 4. CUTTING DATA SAVED ON SD CARD
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
APPENDIX A
APPENDIX A
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
INDEX
INDEX
3-3