GRAPHTEC CC300-20 Craft ROBO User Manual page 43

PREFACE
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
The design orientation has not been specified correctly. Please check the "Design
Orientation" setting in your application program.
 Make the setting once again. If the problem is still not resolved, consult the manufacturer of the
application software that you are using.
The distances between the registration marks have not been specified correctly.
Please check the "Distance between Registration Marks" setting in your application
program. (Displayed only for the CC330-20.)
 Make the setting once again. If the problem is still not resolved, consult the manufacturer of the
application software that you are using.
The specified Media Type cannot be used. Please specify a different Media Type.
 The default Media Type has been specified, or characters ( / : * ? < >) that cannot be used for
the Media Type name have been specified. Please enter the Media Type name once again.
CHAPTER 3. CRAFT ROBO CONTROLLER
CONTENTS
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
CH 4. CUTTING DATA SAVED ON SD CARD
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
APPENDIX A
APPENDIX A
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
INDEX
INDEX
3-19