GRAPHTEC CC300-20 Craft ROBO User Manual page 16

PREFACE
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
(3) Press  or  on the control panel to select <Load Media>, and press [ENTER].
Load
Media
 When the SD card is not set in the SD card slot
 When the SD card is set in the SD card slot
The Craft ROBO feeds the media automatically.
How to unload the meda
Press  to select <Unload Media>, and press [ENTER].
Unload
Media
The media is output toward the front of the main unit.
CHECKPOINT
Allowable cuttng area
Make sure that your design fits within the allowable cutting area indicated below.
If the media is A4 size
Standard mode: The width of the allowable cutting area is 190 mm.
Expanded mode: The width of the allowable cutting area is 200 mm.
If registration marks are used, the allowable width is 190 mm.
CHECKPOINT
CHAPTER 2. CONNECTION AND PREPARATION
CONTENTS
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
CH 4. CUTTING DATA SAVED ON SD CARD
Unload

Media
Select

File
Load

Media
When cutting is finished, <Unload Media> is displayed on the screen. In this case, just
press [ENTER] to unload media.
• Follow the procedure below to change the mode from Standard to Expanded or
viceversa. The default setting is "Standard" mode.
1. In the Control Panel, open "Printers" ("Printers and Faxes" for Windows XP).
2. Open "Properties" for Graphtec CC300 or CC330.
3. Click [Printing Preferences] in the "General" tab.
4. Select the desired mode in "Margins" on the "Basic Setup" tab.
(If you create the cut data using the ROBO Master or Cutting Master 2, the [Expanded]
mode is selected.)
• The allowable cutting area indicated above is applicable only when the media is set
correctly.
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
APPENDIX A
APPENDIX A
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
INDEX
INDEX
2-9