Cutting.with.new.tool.conditions - GRAPHTEC CC300-20 Craft ROBO User Manual

PREFACE
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
(5) Press  or  to select the file name of the data you want to cut, and press [ENTER].
File005
25 100%
e.g. "File 005" is displayed
CHECKPOINT
(6) Press  or  to select <Yes>, <No>, or <Area>, and press [ENTER].
Cut?
Yes
<Yes>: The Craft ROBO cuts the media from the point where the tool is located. If the cutting
data includes registration marks, the Craft ROBO searches the marks from the origin point
automatically, detects the marks, and then cuts the media.
<No>: Cutting is canceled.
<Area>: The Craft ROBO cuts the media after confirming the cutting area.
<Confirming the cutting area>
If you select <Area>, the Craft ROBO moves the tool to the last coordinate of the cutting data
and checks if the cutting area is within the media size. If the cutting data includes registration
marks, the Craft ROBO searches the marks from the origin point automatically, detects the
marks, moves the tool to the last coordinate of the cutting data, and confirms the cutting area.
<OFFSCALE>: The cutting area exceeds the media size. Press [ENTER] to display <Cut?>. To
start cutting, press < or > to select <Yes>, and press [ENTER]. To cancel cutting, press
 or  to select <No>, and press [ENTER].
<PRESS ENTER>: The cutting area is within the media size. Press [ENTER] to display
<Cut?>. To start cutting, press < or > to select <Yes>, and press [ENTER]. To cancel cutting,
press  or  to select <No>, and press [ENTER].
(7) When cutting is complete, make sure that <Unload Media> is displayed, and press [ENTER].
Unload
Media
The media is output toward the front of the main unit.
Cuttng the same mage repeatedly (Copy)
You can cut the same image repeatedly by setting the number of copies.
(1) Follow the steps 1 to 4 in "Cutting with new tool conditions."
(2) Press  or  to select <Copy>, and press [ENTER].
Copy
1
(3) Press  or  to set the number of times you want to cut the same image, and press [ENTER].
CHAPTER 4. CUTTING DATA SAVED ON SD CARD
CONTENTS
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
CH 4. CUTTING DATA SAVED ON SD CARD
Cut?

Yes
• The file name is displayed in the upper line, and the force and scale set for the previous
cutting operation are displayed in the lower line on the file selection screen.
• If <No File> or <Unknown File> is displayed, see Section 4.3, "Error Messages."
Working...

Load w/

Carrier
Copy

■ 1
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
APPENDIX A
APPENDIX A
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
INDEX
INDEX
4-5