Starting.up.the.craft.robo.controller - GRAPHTEC CC300-20 Craft ROBO User Manual

PREFACE
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
Click [Install] to continue.
(4) The screen below is displayed.
Click [Install] to continue.
(5) If the screen below is displayed, click [OK] to restart your computer.
3.3 Starting up the Craft ROBO Controller
The Craft ROBO Controller can be started up from the [Start] menu on the Windows desktop or from the
Craft ROBO-compatible software such as ROBO Master.
(1) Press the Standby switch on the Craft ROBO, and check that the LED lamp is lit (green).
(2) Check that the Craft ROBO and your computer are connected by a USB cable.
Startng up from the Wndows [Start] menu
The Craft ROBO Controller can be started up from the Windows [Start] menu. To start it up, select
"Start"  "(All) Programs"  "Craft ROBO"  "Craft ROBO Controller".
CHECKPOINT
CHAPTER 3. CRAFT ROBO CONTROLLER
CONTENTS
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
CH 4. CUTTING DATA SAVED ON SD CARD
Cutting operation other than test cut cannot be done when you start the controller from
the Start menu.
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
APPENDIX A
APPENDIX A
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
INDEX
INDEX
3-5