GRAPHTEC CC300-20 Craft ROBO User Manual page 34

PREFACE
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
3.5 Craft ROBO Controller Settings
When the Craft ROBO Controller is started up, the following screen appears.
When Craft ROBO-compatible software (Such as ROBO Master)
was used to start up the Controller
Hide/Show the operation guide
............................. When the Craft ROBO Controller is started up, an operation guide is displayed at
About ............................. Click to display the version information of the Craft ROBO Controller currently in use.
Help ................................ Click to display Quick Help descriptions of the various Craft ROBO functions.
Cancel ............................ Click to exit the Craft ROBO Controller.
Cut ................................. Click to start cutting with the Craft ROBO. If your model is the CC330-20 and the
Media Type .................... Use this drop-down box to select the type of media to be cut.
3-10
CONTENTS
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
CH 4. CUTTING DATA SAVED ON SD CARD
the bottom of the window. The [Hide/Show the operation guide] button turns the
operation guide function on/off. Use the [Previous] and [Next] buttons provided
within the operation guide to display the screens in succession and check the
current settings for each parameter. Follow the step-by-step instructions for easy
Craft ROBO setup and operation.
automatic reading of registration marks is specified, the registration marks are read
first. When the registration marks have been read successfully, the Craft ROBO
starts cutting.
The following 8 Media Type parameters are provided:
<Graphtec media>
• Card without Craft Paper Backing*1
• Card with Craft Paper Backing
• Vinyl Sticker*1
• Film Labels*1
• Magnetic Sheet*1
*1: CC330-20 only
All of the above parameters are for media that is supplied by Graphtec.
CHECKPOINT
When using Graphtec-supplied media, be sure to select the correct
parameter for the media that you are using. For further details on
Graphtec-supplied media, please see the Graphtec web site.
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
APPENDIX A
APPENDIX A
When the Windows [Start] menu
was used to start up the Controller
CHAPTER 3. CRAFT ROBO CONTROLLER
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
INDEX
INDEX