GRAPHTEC CC300-20 Craft ROBO User Manual page 14

PREFACE
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
How to unload the carrer sheet
Press  to select <Unload Media>, and press [ENTER].
Unload
Media
The carrier sheet is output toward the front of the main unit.
CHECKPOINT
Allowable cuttng area of the carrer sheet
Make sure that your design fits within the allowable cutting area indicated below.
190mm
305mm Allowable cutting area
10mm
Standard mode
• Follow the procedure below to change the mode from Standard to Expanded or vice versa. The
default setting is "Standard" mode.
1. In the Control Panel, open "Printers" ("Printers and Faxes" for Windows XP).
2. Open "Properties" for Graphtec CC300 or CC330.
3. Click [Printing Preferences] in the "General" tab.
4. Select the desired mode in "Margins" on the "Basic Setup" tab.
(If you create the cut data using the ROBO Master or Cutting Master 2, the [Expanded] mode is
selected.)
• The allowable cutting area indicated above is applicable only when the media is set correctly.
CHAPTER 2. CONNECTION AND PREPARATION
CONTENTS
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
CH 4. CUTTING DATA SAVED ON SD CARD
Load w/

Carrier
When cutting is finished, <Unload Media> is displayed on the screen. In this case, just
press [ENTER] to unload media.
305mm
10mm
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
APPENDIX A
APPENDIX A
200mm
Allowable cutting area
5mm
Expanded mode
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
INDEX
INDEX
Set the arrow faced toward
Craft ROBO main unit.
5mm
2-7