GRAPHTEC CC300-20 Craft ROBO User Manual page 46

PREFACE
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
<No>: Cutting is canceled.
<Area>: The Craft ROBO cuts the media after confirming the cutting area.
<Confirming the cutting area>
If you select <Area>, the Craft ROBO moves the tool to the last coordinate of the cutting data and
checks if the cutting area is within the media size. If the cutting data includes registration marks,
the Craft ROBO searches the marks from the origin point automatically, detects the marks, moves
the tool to the last coordinate of the cutting data, and confirms the cutting area.
<OFFSCALE>: The cutting area exceeds the media size. Press [ENTER] to display <Cut?>. To
start cutting, press  or  to select <Yes>, and press [ENTER]. To cancel cutting, press  or 
to select <No>, and press [ENTER].
<PRESS ENTER>: The cutting area is within the media size. Press [ENTER] to display <Cut?>. To
start cutting, press  or  to select <Yes>, and press [ENTER]. To cancel cutting, press  or 
to select <No>, and press [ENTER].
(7) When cutting is complete, make sure that <Unload Media> is displayed, and press [ENTER].
Unload
Media
The media is output toward the front of the main unit.
Cuttng wth new tool condtons
(1) Press the standby switch and confirm that the LED lamp is lit (green).
(2) Insert the SD card into the SD card slot.
(3) Load the media, and press [ENTER]. (See Section 2.3, "Loading Media using the Carrier
Sheet," and Section 2.4, "Loading Media without Using the Carrier Sheet (CC330-20 Only).")
Load w/
Carrier
(4) Press  or  to select <Setting>, and press [ENTER].
Setting
(5) Press  or  to select <Select Media>, and press [ENTER].
Select
Media
(6) Press  or  to select the media type, and press [ENTER].
Thick
You can select the media type from <Thick>, <Thin>, <Film>, or <Pen>.
The preset force for the selected media type is displayed.
(7) As necessary, press  or  to adjust the force, perform a test cut, and then press [ENTER].
Force: 10
S+E:TEST
CHAPTER 4. CUTTING DATA SAVED ON SD CARD
CONTENTS
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
CH 4. CUTTING DATA SAVED ON SD CARD
Load w/

Carrier
Select

File
Select

Media
Thick

Force:33

S+E:TEST
Start

Point
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
APPENDIX A
APPENDIX A
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
INDEX
INDEX
4-3