Remote Reporting - Dedicated Micros DV-IP Express Nstallation And Operation Manual

Table of Contents

Remote Reporting

This menu details the configuration requirements for the unit to report to a Remote Video Receiving

Centre (RVRC) following alarm activation.

Note: This menu will only be displayed if 'Remote Reporting' is selected in the

System Settings:-Features menu.

�rimary Hostname

�rimary Dial �rofile

Secondary Hostname

Secondary Dial �rofile

�ublic (N�T) �� ddress

�ideo Ser�er �ort

�larm Ser�er ref. �D

This is the �� address or UR� of the initial host that the unit will

transmit an alarm message to.

�t is possible for the alarm message to be transmitted �ia the

�thernet network or a dial up connection.

�f the unit is unable to contact the primary host, an alternati�e

route can be identified �ia a secondary host. �f there is only one

alarm recei�ing �� address, you must enter the details in both the

primary and secondary connection settings.

�t is possible to select a separate dial profile for the

secondary host.

This is the public �� (or domain name) for a unit connected to

the �nternet �ia a N�T Router or Firewall. This field should be left

blank if N�T is not used e.g. a pri�ate network.

This field allows the R�RC to connect to the unit through a router

that is using port forwarding e.g. if the �ideo ser�er does not

appear on port 80 (HTT�), to the e�ternal network. �nter the port

number used for fowarding here if required.

This is the reference name��D that will be presented to the R�RC

�iewing application. �t should therefore ha�e some significance to

the Operator.

Table of Contents

Do you have a question about the DV-IP Express and is the answer not in the manual?