Dedicated Micros DV-IP Express Nstallation And Operation Manual page 18

Step  Connecting Telemetry Cameras
Simple Dome Connection
Pin connections for RS485 connection to a dome on serial port 3/4 are:
�f the dome is being connected using an RS485 connection, the dome address should be set
to match the camera input number on the D�-�� ��press i.e. if the dome is connected to �ideo
input 3, the camera address should be '03'.
Dennard 00 & 00 Domes
A Dennard 2040/2060 Dome can be connected via either co-axial telemetry or RS485 twisted
pair.
�f using co-a�ial telemetry the address switches should be set as:
DM Oracle Domes
A DM Oracle dome can be connected via either co-axial telemetry or RS485 twisted pair. Oracle
Domes are configured using the specific pages available in the unit software, refer to 'Oracle
Dome Configuration' for more information.
The D� Oracle Dome has three address switches, refer to the Oracle Dome documentation for
more information on hardware confguration.
Note: To enable configuration of Oracle Dome menus, an RS485 connection is required.
1
Dome Cable D�-�� ��press Serial Connector
��ellow 1
Green 9
�lue switch - F ��ellow switch - D
UTC
Red - 1
Blue - N/R
��ellow - N�R
Serial
Red - 2
�lue - Camera Number
��ellow - Camera Number
TX+
TX-
Dedicated Micros ©2009