Using The Ir Remote Control - Dedicated Micros DV-IP Express Nstallation And Operation Manual

Table of Contents

Using the IR Remote Control

By default, the I.R. Remote Control will be in "DVR" mode. If the unit does not respond to commands

from the Remote Control, pressing the "DVR" button will always return the Remote Control to "DVR"

mode. Pressing the "TV" button will switch to "TV" mode and send codes understood by common

television sets (when preprogrammed to do so: see Appendix B).

Pressing any of the coloured Softkeys at any time will display the 'coloured' keys first and then

access the equivalent 'coloured' option displayed in the menus.

For a description of the button commands available on the IR Remote Control, refer to the

'IR Remote Control' section.

Using the optional Keyboards (DM/KBC1 & DM/KBC)

The unit can also be controlled using an optional Dedicated Micros keyboard. This is connected via

the KBD connector on the rear of the DV-IP Express and provides the same control functions as the

I.R Remote Control. The following keyboards are supported:

DM/KBC1 Keyboard

Table of Contents

Do you have a question about the DV-IP Express and is the answer not in the manual?