Installing The Switch - Seagull Models SPARROW HAWK 62 CC Assembly Manual

Type B2.
Type B3.
Machine screw 3 x 15 mm.
3) Install the muffler and muffler extension
onto the engine and make the cut out in the
cowl for muffler clearance. Connect the fuel
to the carburetor, muffler and fuel filler valve.
Secure the cowl to fuselage using the 3x15mm
screws (4).
Type B4.
INSTALLING THE FUSELAGE SERVO.
Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
1) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the servo
into the aileron servo mount.
2) Secure the servos with the screws pro-
vided with your radio system.
www.seagullmodels.com
side of the fuselage.
pictures shown below.
Elevators Servos.
Rudder Servo. Throttle Servo.

INSTALLING THE SWITCH.

Install the switch into the precut hole in the
Switch.
INSTALLING FIN SET 1.
1) Remove the covering as same as
Remove covering.
13