Wing Assembly; Wheel Pant Installation - Seagull Models SPARROW HAWK 62 CC Assembly Manual

SPARROW HAWK
Machine screw 3 x 10 mm.
Epoxy glue.
Be careful do not to drill through the
top of the wing!

WHEEL PANT INSTALLATION.

The wheel pant assembly follow pictures be-
low.
Machine screw 3 x 15 mm.
8
Instruction Manual
Machine screw 3 x 15 mm.
Reinstall the gear wire and install the four 3 x
15mm wood screws. Tighten the screws com-
pletely to secure the gear wire in place.

WING ASSEMBLY.

NOTE: We highly recommend using 30
minute epoxy as it is stronger and provides
more working time, allowing the builder to
properly align the parts. Using fast cure epoxy
when joining the wing halves could result in the
glue drying before the wing halves are aligned
properly which may result in failure of the wing
centre section during flight.
1) Test fit the Wing tube into each wing half.
The brace should slide in easily up to the
centreline that you drew. If not, use 220 grit
sandpaper with a sanding block and sand
down the edges and ends of the brace until it
fits properly.
Masking tape.
glue.
glue.