Removing Upper Cover - Hitachi RAS-5HVRNM1E Service Manual

10 Servicing
¿ Removing air outlet grille
1 Remove the four (4) fixing screws.
2 Lift the air outlet grille holding the lower parts.
3 Release the extruded hook of the air outlet grille from the
shroud.
1. Air outlet grille.
2. Shroud.
¿

Removing upper cover

1 Remove the eleven (11) fixing screws.
2 Lift the upper cover upwards.
1. Upper cover.
¿ Removing outdoor fan motor
1 Remove the service cover according to the section
2 Remove the air outlet grille according to the section
3 Remove the upper cover according to the section
4 Disassemble the fan blade by removing the cap nuts and washers fixing the fan blade onto the motor shaft.
5 Remove the fan motor connector from the PCN202 at the electrical box.
• Cut off the cable tie that fixes the lead wire of the fan motor.
• Remove the four (4) screws that fix the motor to the motor clamp.
356
SMGB0060 rev. 1- 12/2010
1
Removing service cover, see on page 355 in this chapter.
Removing air outlet grille, see on page 356 in this chapter.
Removing upper cover, see on page 356 in this chapter.
2
1