Transportation Of Outdoor Unit - Hitachi RAS-5HVRNM1E Service Manual

2 Unit Installation

2.2 Transportation of outdoor unit

D A N G E R
• Do not put any foreign material into the outdoor unit and check to ensure that none exists in the outdoor unit
before the installation and test run. Otherwise, a fire or failure will occur.
Hanging Method
When hanging the unit, ensure the balance of the unit, check safety and lift it up smoothly. Do not remove any packing
materials and hang the unit under packing condition with two ropes, as shown below.
RAS-3HVRNME
RAS-(2-3)HVRN(1)(E)(S)
RAS-(4-6)HVRNS1E
1
1. Wire rope.
A. Over 60º.
B. 0.7 to 1.0 m.
C. Do not remove the plastic band or the corrugate paper frame.
D. Pass the wire ropes through each lifting hole in the wooden base as shown.
C A U T I O N
• Lift the outdoor unit in its factory packaging with 2 wire ropes.
• For safety reasons ensure that the outdoor unit is lifted smoothly and does not lean.
• Do not attach lifting equipment to the plastic band or the corrugated paper frame, because of the ropes will slip
or break the materials.
• Ensure that the exterior of the unit is adequately protected with cloth or paper.
9
SMGB0060 rev. 1- 12/2010
A
B
C
D
RAS-(4-6)H(V)RNM1E
RAS-(8-12)HRNM
RAS-(8/10)HRNSE
A
1
B
C
D
2