10 Servicing
•
Remove the noise filter by clamping the top of the holder (6 portions) with a pincher.
•
Identify the terminal numbers with mark band. When reassembling, the terminals have to be connected to the
correct numbers . If incorrectly connected, malfunctions or damages will occur.
10.2.2 Outdoor units RAS-(4-6)H(V)RNM1E
¿
Removing service cover
N O T E
•
Remove the main parts according to the following procedures.
–
To reassemble perform the procedures in reverse.
–
To prevent contamination of the refrigerant with water or foreign particles, do not expose open to
atmosphere for long periods.
–
If necessary, seal pipe ends using caps or tape.
1
Remove the four (4) fixing screws.
2
Slide the service cover downward and remove it.
3
Pay attention of not falling off the service cover.
1. Service cover.
¿
Remove air outlet grille
1
Remove the eight (8) fixing screws.
2
Lift the air outlet grille holding the lower parts.
3
Release the extruded hook of the air outlet grille from the
shroud.
1. Air outlet grille.
2. Shroud.
366
SMGB0060 rev. 1- 12/2010
1
2
2
1