10 Servicing
10.2 Servicing for IVX series
10.2.1 Outdoor unit RAS-3HVRNME
¿
Removing service cover
N O T E
•
Remove the main parts according to the following procedures.
–
To reassemble perform the procedures in reverse.
–
To prevent contamination of the refrigerant with water or foreign particles, do not expose open to
atmosphere for long periods.
–
If necessary, seal pipe ends using caps or tape.
1
Remove the three (3) fixing screws.
2
Slide the service cover downward and remove it.
3
Pay attention of not falling off the service cover.
1. Service cover.
¿
Removing bottom service cover and rear cover
1
Remove five (5) screws which fix the bottom service cover. Pull and remove the bottom service cover.
2
Remove the upper cover following
3
Remove seven (7) screws which fix the rear cover (eight (8) screws for two-fan models; the inlet grill is fixed with four
(4)). Pull backward and remove the rear cover.
1
3
1. Outlet grille.
2. Rear cover.
3. Bottom service cover.
355
SMGB0060 rev. 1- 12/2010
Removing service
cover, see on page 355.
2
1. Outdoor air thermistor attachment.
2. Inlet grille.
3. Rear cover.
1
1
2
3
10