CyberData 011186 Operation Manual page 50

2.4.7.2 Point-to-Point Configuration
When the device is set to not register with a SIP server (see
device to dial out to a single endpoint.
In this case, the dial-out extension should be the IP address of the remote device. The device can
also receive Point-to-Point calls. The delayed DTMF functionality is available in the Point-to-Point
Mode.
Note
Operations Guide
Receiving point-to-point SiP calls may not work with all phones.
Figure 2-21. SIP Page Set to Point-to-Point Mode
Device is set to NOT register with a SiP server
930796N
Installing the VoIP Outdoor Intercom
Figure 2-21), it is possible to set the
CyberData Corporation
43
Intercom Setup